山泉AM-111聚氨酯建筑嵌缝密封胶　

SHANQUAN AM-111 PU Sealant for Constructional joint sealing

●产品描述Description

　　山泉AM-111为100%聚氨酯建筑嵌缝密封胶，中性、湿气固化,且固化过程无毒无味，与建筑材料表面有良好的粘接力。具有良好的耐候性、弹性及耐低温性能,耐水性、抗烟雾性强。

　　SHANQUAN AM-111 is PU sealant for constructional joint sealing. It is neutral and is cured by reacting with moisture in air. During the curing process，it won’t produce any poison and pollution on the base surface. It can adhere to constructional materials well. It has good resistance to elements、good elasticity、good low temperature resistance and good resistance to fog.

●技术数据Technical Date

●应用范围Areas of Application

　　1.大理石、玻璃、铝塑板幕墙等嵌缝密封。

　　2.内、外墙填缝、防水密封，采光天棚、建筑伸缩缝、沉降缝的密封。

　　3.市政工程、排污管道的防水密封等，隧道及道路工程的混凝土伸缩缝密封，陶瓷工程的粘接及填缝密封。

　　1.Joint sealing of marble、glass、curtain and so on.

　　2.Sealing of inner 、outer wall， waterproof， lighting sunshade，dilatation joint and settlement joint.

　　3.Waterproof Sealing of municipal project、sewage conduit，sealing of dilatation joint of tunnel and road project，adhesion and sealing of ceramics.

●施工方法Method of Application

　　1.用棉纱清除涂胶部位表面的尘土、油污及明水。如果表面有易剥落锈蚀，应事先用金属刷清除，必要时还可用酒精、丙酮等有机溶剂擦拭表面。

　　2.根据施工部位的形状将密封胶的尖嘴切成一定形状的大小，用手动或气动胶枪将胶涂在施工部位。

　　3.缝隙中鼓出的胶可用刮板刮平或肥皂水抹平。如有的部位不慎被胶所污染，则尽早用汽油或酒精等溶剂清除。如胶已固化，需要用刀片切割或打磨。

　　1.Cleaning away dust，greasy dirt and clear water of the glued surface by cotton yarn. If the surface contains rust，which should be in advance cleaned away by metallic brush， in addition to，can also wipe the surface.

　　2.The nozzle is sheared as required size and screwed on the sealant，then the sealant with the nozzle is used by the manually-operated or the compressed-Air pistol.

　　3.The superfluous sealant from the gap may be pared off by the pattern strickle or suds. It is necessary to be cleared away at once by using benzene if the rest part is polluted by the sealant. It is necessary to cut or burnish by knife if the sealant cured.

●包装Package

　300ml铝管Cartridge                           12支/箱

　400ml、600ml软包装Sausage                   20支/箱

　小桶Can                                     约23kg/桶

　大桶Drum                                   约230kg/桶

●贮存 storage

　　建议在25℃以下的干燥库房内，避免高温/水汽，贮存期一般为9个月。

　　We suggest the products should be stored in the dry place bellow 25℃，avoid high temperature and moisture. The shelf life is nine months.

●注意事项 Attention

　　1.开封后应当天用完，否则需严格密封保存；

　　2.在温度15-35℃、湿度55%-75%RH条件下施工 ；

　　3.当环境温度低于10℃或出胶速度达不到工艺要求时，建议在60℃烘箱里至少烘烤30分钟！

　　1.If the sealant is opened，it should be used up the same day；otherwise it should be conserved strictly.

　　2.The best work condition is at the temperature of 15-35℃ and at the degree of humidity of 55%-75% RH.

　　3.When the environment temperature is below 10℃，or extrusion below craft requirement，we suggest sealant be roasted for 30min in the oven.